Rugged-ridge Storage Ends, XHD Modular Front Bumper Manual de usuario descargar pdf

2007 Jeep® JK Wrangler Modular XHD Front Bumper Storage Ends

Contents:

1. Left Storage End (1)

2. Right Storage End (1)

1. Storage Ends are easier to install with the Center Section of Modular XHD Bumper off of the vehicle,

but can be installed with the Center Section already installed. If Storage Ends are replacing

previously installed Stubby Ends (Figure 1a), remove them so that empty ends remain (Figure 1b).

2. Position Storage Ends to the ends of the Center Section, aligning the studs in the Storage Ends with

the holes in the sides of the Center Section (Figure 2a). Insert the studs in the Storage End into the

holes in the Center Section and secure them with the nuts that came with the Center Section.

Page 1 of 2

Figure 1b

Figure 1a

Remove

11540.22

NOTICE: Failure to lock lids of XHD Storage Ends could result in loss of lids and/or damage to vehicle components.

Always double check to make sure lids are properly locked before operating the vehicle.

1 2

2007 Jeep® JK Wrangler Modular XHD Front Bumper Storage EndsContents:1. Left Storage End (1)2. Right Storage End (1)1. Storage Ends are easier to i

3. Once all 6 nuts have been started, tighten them. Installation is now complete!Page 2 of 2Congratulations on the purchase and installation of a qu

Sin comentarios

Rugged-ridge Storage Ends, XHD Modular Front Bumper Manual de usuario